-
EnvironmentData from the underway system includes observations and measurements of meteorological (e.g. air temperature, atmospheric pressure, relative humidity, wind speed and direction) at 10m above sea level and oceanographic (e.g. sea surface temperature/salinity) at approximately 3m...
-
This dataset represents an initial comparison between several years of hourly wave forecasts (using WAM) on a grid of points located off the Irish coast with corresponding records from a number of buoys installed pre 2005. Based on the level of agreement found the wave...
-
The hydrodynamic model, ROMS (Regional Ocean Modeling System), is run for a domain that covers a significant portion of the northeast Atlantic at a resolution of 2.5 km and and with 40 vertical levels.7-day forecasts are generated for research purposes and for comparison with...
-
The Full Scale Atlantic Marine Energy Test Site (AMETS) provides 30 minute observational data from two directional waverider buoys known as Belmullet A and Belmullet B observing and measuring wave height, wave direction and wave period. The AMETS buoys are located in the North...
-
Estimated annual average wave period (seconds) created by a Pelamis Wave Model for Accessible Wave Energy Resource Atlas. Wave period values are measured as lower and upper values in seconds as calculated by the Pelamis wave model. Annual average wave period covers an area...
-
EnvironmentThe dataset provides sea surface temperature and sea temperature information from a network of internal logging temperature sensors at 17 locations around the Irish coast. The TidbiT Temperature loggers have recorded hourly at each site providing a comprehensive time series...
-
Acoustic Doppler Current Profile (ADCP) hydroacoustic current meter data is similar to a sonar, attempting to measure water current velocities over a depth range using the Doppler effect of sound waves scattered back from particles within the water column. The term ADCP is a...
-
This dataset represents an initial comparison between several years of hourly wave forecasts (using WAM) on a grid of points located off the Irish coast with corresponding records from a number of buoys installed pre 2005. Based on the level of agreement found the wave...
-
Monthly mean (average) values for oceanographic parameters in the North Atlantic Ocean SWAN and ROMS models. Mean values have been calculated on a monthly basis include sea surface temperature (degreeCelsius), sea bottom temperature (degreeCelsius), sea surface salinity (PSU),...
-
EnvironmentWave climate forecasts including significant wave height, mean wave period, mean wave direction, wave per unit crest length, peak period and energy period at Marine Institute weather and wave buoy locations.
-
Estimated annual average wave height (metres) created by a Pelamis Wave Model for Accessible Wave Energy Resource Atlas. Wave height values are measured as lower and upper values in metres as calculated by the Pelamis wave model. Annual average wave height covers an area...
-
EnvironmentA tidal atlas or a tidal stream atlas is used to predict the direction and speed of tidal currents. A tidal atlas usually consists of a set of 12 or 13 diagrams, one for each hour of the tidal cycle, for a coastal region. Each diagram uses arrows to indicate the direction of...
-
EnvironmentCTD or Conductivity Temperature Depth stations measure temperature, conductivity and depth of the water column at various depths from the surface to within 10m of the seafloor. A CTD is the oceanographic instrument used to determine the conductivity, temperature, and depth of...
-
This dataset represents an initial comparison between several years of hourly wave forecasts (using WAM) on a grid of points located off the Irish coast with corresponding records from a number of buoys installed pre 2005. Based on the level of agreement found the wave...
-
SWAN (Simulating Waves Nearshore) is a third-generation wave model which was primarily developed for use in coastal regions. The operational East_Atlantic model used to generate this dataset was an implementation of the SWAN model for Irish waters. The East Atlantic SWAN Wave...
-
The cruise track inventory shows the locations of surveys completed by the RV Lough Beltra research vessel. The geographic coverage of the Lough Beltra is mainly in inshore areas around Ireland including the Irish Sea, Saint George's Channel, Celtic Sea and North Atlantic...
-
The hydrodynamic model, ROMS (Regional Ocean Modeling System), is run for a domain that covers a significant portion of the northeast Atlantic at a resolution of 2.5 km and and with 40 vertical levels.7-day forecasts are generated for research purposes and for comparison with...
-
SWAN (Simulating Waves Nearshore) is a third-generation wave model which was primarily developed for use in coastal regions. The operational East_Atlantic model used to generate this dataset was an implementation of the SWAN model for Irish waters. The East Atlantic SWAN Wave...
-
Research cruise survey tracks generated from underway and windmill stations for Celtic Voyager cruises completed between 1997 and 2015. Survey operations have been undertaken across many scientific disciplines including geology, biology, chemistry, oceanography and marine...
-
SWAN (Simulating Waves Nearshore) is a third-generation wave model which was primarily developed for use in coastal regions. The operational East_Atlantic model used to generate this dataset was an implementation of the SWAN model for Irish waters. The East Atlantic SWAN Wave...